1. Lay out the entire kit for easy assembly2. Place Viton Oring on Reservoir3. Place reducer on reservoir4. Loosely place clamp over reservoir assembly5. Place reservoir heater wires the space in the reservoir clamp and tighten the clamp6. Wrap reservoir with reservoir heater and retain with included velcro7. Place retaining clamp on retort stand8. Place heater assembly on retort stand and secure the retaining screw9. Thread in quick connect fitting. Make sure to use pliers or a wrench to ensure no leaks10. Place the line in the fitting. Make sure to use 30lbs of force to ensure a airtight seal. You will hear a click and a thud11. Hook the spring hook from the wired end on to the reservoir clamp12. Wrap the heat belt loosely around the reservoir twice13. Run the heat belt over the retaining spring, and pull tight to secure14. Wrap the heat belt over the line15. Secure spring hook over syringe tip
Filling
SOP, iCell Ceramic Snap on Cartridges
Thank
you for your interest in the Ascent iCell ceramic snap on cartridge.
These cartridges are known... read more
Comments (5)
NEED a Gun build video.
Oil cools inside the gun itself even with the heat band wrapped around it…
Hey I was wondering if you have any tutorial videos on gun assembly and disassemble for worn gaskets?
Is there a video of the gun assembly?
Do you have a video or a picture set up of putting the gun together?