Cart Farmer Usage Tutorial
Once your cart farmer is assembled, it is time to put it to use. The first step of usage is plugging the cart farmers in.
To set, press the SET button. The set temp will be blinking in degrees centigrade. Cycle the set temperature higher and lower utilizing the up and down buttons.
The line should be set to the % of your carrier oil. For a 90/10 blend you set the line to 90c and for a 97/3 blend, you set the line to 97c, and so fourth.
The reservoir heater can be a lower temperature to preserve aromatics. Set the reservoir to 60-70% of the temperature of your line. For a 90/10 you will set to 63c and for 95/5 you will set to 66c and so on.
Once turned on an set, allow 10 minutes for your cart farmer to reach your desired temperature.
Preheat your material to the reservoir heat level.
Pour your material into the reservoir
Fire 10 shots into the reservoir to bring material into the line.
Fire another shot into the reservoir, hold the plunger depressed, and hold the gun lower than the reservoir. Release the plunger slowly to fill the chamber. Repeat this step if an air bubble is present.
For the CF-50, one only needs to fire one or two priming shots only. These can be fired into a cartridge or into the material container.
Comments (3)
Will there/are there any videos be available for the usage of this machine?
We have a CF1000 tutorial on our YouTube channel here: https://youtu.be/Ns0yHbgGJU8
More videos coming soon!
its private